The resin, curing agent and filler components are weighed perfectly in the correct ratio. Then mix it manually or by mechanical mixer to obtain a uniform color mix of all the above components. It is recommended to let the mixed material stand free for few minutes to release entrapped air.
To get highest bond strength, apply one primer coat of unfilled resin & curing agent in
recommended mix ratio is to be applied on both concrete & steel surface. Allow it to touch dry
stage. Then grouting the mix care should be taken to avoid any air pockets. Tamping with rods or vibrator is recommended, as a suitable measure.
To get good result, it is necessary that both the concrete & steel surface should be clean and free from any oil, grease. The foundation bolt/base plate should be prepared thoroughly wire-brushing or roughening with emery paper. Degreasing with a solvent like acetone, benzene or toluene is then recommended. Please see technical data sheet on surface standards for
|Compressive Strength kg/|
|Flexural Strength kg/cm2||450-500||300-400|
|Pot Life @ 25o C Min.||45-60||45-60|